Packaging Builder prices the pack while it can still change. Alter a material or a weight and watch the fee move, re-priced against the same cited rates as your dashboard, in every market you sell into.
Most compliance tools tell you what you owe. Packaging Builder helps you owe less. Pick a product you have already loaded, say what matters most, and Oblifee proposes a redesign: materials, target weights, kerbside acceptance in each market, and the fee difference, re-priced against the same cited rates as your dashboard.
Every market · every regime · cited absences
Illustrative only, at 120,000 units a year against the cited GB base rates for paper and plastic. In your workspace the same calculation runs on your products, your volumes and every market you sell into.
Four steps, and the last one is the point: nothing is a guess at a number. Every fee in the concept comes from the same cited rates that drive your dashboard.
Search by SKU, name, category or business. It uses the packaging components and despatch volumes already in your workspace, so there is nothing new to type.
Cut fees and cost, lightweight, maximise recyclability, reduce single-use plastic, balanced, or global compliance - and you can combine goals. What you choose changes what gets traded away.
Attach a photo, render or dieline. Obli reads what the design reveals about construction and keeps the concept true to your brand look.
Materials, target weights, kerbside verdicts per market, a validation checklist, risks to check, and the annual fee difference at your real volumes.
The same pack has different best answers depending on what you are optimising for. Choose a goal, or combine several, and the concept changes with them. The global compliance goal goes furthest: it judges the concept against every packaging jurisdiction in the brain, so one design can travel.
Six goals, combinable: cut fees and cost, lightweight, maximise recyclability, reduce single-use plastic, balanced, or global compliance.
Component by component: keep, change, add or remove, with the material and a target weight for each, and the construction written out.
Judged against the schemes' own rules, not a rule of thumb.
Annual EPR impact at your current volumes and current cited rates. Eco-modulation bonuses are deliberately not applied, so qualifying can only improve on the figure shown.
What could go wrong with the change, and what to validate before anyone commits tooling to it.
Attach your artwork and Oblifee can draw the proposed pack from it, so the change is something you can look at rather than only read. It is an illustration, and it says so.
The whole concept as one document, with the rates it was priced against and the date they were read, ready for your converter or your board.
Redesign is not only about the pack. Once the Labelling checker has verified a product, the AI label design generator can take the result further: front and back pack design concepts, built from your own artwork rather than a template, for the markets you choose or the whole world.
Generate for chosen countries or every market at once, at the go-live year you set, so the concept carries what will be required by then, not only what is required today.
Concepts start from the artwork you already checked, so the brand look survives. Where one label cannot carry every market, it suggests peel labels to bridge the gap.
Every generated design is a concept to verify before print, and is labelled as one. It shortens the route to approved artwork; it does not replace the approval.
A redesign concept is not a manufacturing specification. Validate materials, weights, closures and product compatibility with your packaging converter before changing anything. Packaging Builder is built to make that conversation shorter and better informed, not to replace it.
Figures are estimates from your data and currently cited EPR rates. Where a rate is illustrative or estimated rather than confirmed, it stays labelled that way, here as everywhere else in Oblifee.
Packaging Builder is included in every plan. Load a product, pick a goal, and read the concept in about a minute.
Request accessFees are set by material, weight and recyclability, all of which are decided before tooling is cut. Packaging Builder re-prices a pack as you change it, against the same cited rates as the dashboard, in every market you sell into.
